White Wall Fitment
Step 1
It is critical that the inner rim of the wheel is super clean for the whitewalls to fit, if there is any oil, soap, grease etc then they will slip out and the process will be very frustrating.
Remove the wheel from the car and break the outer bead of the tyre, get a rag with some prepsol or thinners on it and thoroughly clean the inside of the rim where the whitewall will be sitting between the rim and the bead of the tyre.
Step 2
Fit the White Wall Insert to the outer part of the rim, position so it will be sitting in its fitted location. Do not use soap, these need to be fitted dry.
Step 3
Inflate tyre until it POPS back over the bead and lower the tyre pressure to about 18 PSI.
Look at how the White Wall Insert is sitting. If you are satisfied, inflate to correct pressure, rebalance and fit to your car.
Should the White Wall Insert not sit in the desired location with the tyre pressure at about 18 PSI, then use a rubber mallet over a clean cloth over the White Wall Insert and gently tap the White Wall Insert in or out to adjust how it sits until you are satisfied. Then inflate to correct pressure, rebalance and fit to your car.
DO NOT USE ANY LUBRICANT OR ANY GLUE/ADHESIVE